4A. Insert the short connector of the Smart Board serial cable (the long cord) into the 9-pin serial port under the lower right side of the Smart Board and tighten the screws.
TIP: Keep laptop OFF while attaching power cord!
4B. Insert the long connector (the other end) of the Smart Board serial cable into the back of your laptop and tighten the screws. (Match up the female end of the connector to the male port to determine where to insert it. There is only one match.)
4C. Insert the small, round power plug of the adapter into the socket on the right side of the back of the long connector previously connected to the laptop in step 4B. (This step is normally already done- but always check.)
4D. Skip to step 6!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.